-
Ledwell Rental Water Trucks - Rollbacks-Trailers-Dump Trucks
-
Ledwell Hybrid Rollback
Safety and Information -
Ledwell HydraTail and Rollback
Safety and Information -
Ledwell Rollback
Safety and Information -
Ledwell Rollback
-
Ledwell Operational Series | Hydraulic Winch
Learn how to correctly operate a hydraulic winch to load or unload equipment on any manufactured Ledwell truck body or trailer.
To get started, inspect the following:
Overhead & ground obstructions
Winch cable for breakage
Engage PTO inside the cab
Dump the air suspension of the truck or trailer.
Chock the wheels.
If using Ledwell's wireless remote to operate:
Push Winch Out to reel out the winch.
Pull the chain through the tow hook and secure it.
Push Winch In to reel in the winch.
Load Equipment and remember to set the parking brake.
Secure equipment with preferred tie-downs.
Be sure each piece is anchored at four points to secure properly.
To unload, reverse the process.
For more information, reference the operation manual by scanning the QR code at the front of your equipment or visit ledwell.com.
See index of operational videos - https://bit.ly/2wxwWda
**********
Subscribe and hit the bell to be notified when new videos premiere - https://bit.ly/2POTMDS
**********
CONNECT WITH US
FACEBOOK - https://www.facebook.com/ledwellandson
INSTAGRAM - https://www.instagram.com/ledwellandson/
LINKEDIN - https://www.linkedin.com/company/ledwell-&-son-enterprises-inc./
TWITTER - https://twitter.com/ledwellandson -
Ledwell Operational Series | Rollback
Operate your Ledwell Rollback correctly to extend the life of the bed.
To get started, walk around the entire truck to inspect the following:
Hydraulic & Air Hoses
Winch & cable system
Lights
Flooring
Wheels & Tires
Make sure the truck is on level ground.
Position truck far enough in front of the payload to roll bed back
Engage PTO inside the cab
Dump the rollback suspension
Chock the wheels
If using Ledwell’s wireless remote to operate:
Push Stabilizer Down to lower stabilizer until it rests firmly on the ground.
Push Rollback Off to slide the bed towards the rear of the truck until arrow indicator decal is behind mud flaps
Push Bed Lift Up to adjust the angle of the bed.
Load at the lowest possible angle for safety
Alternate sliding and adjusting angle of bed until firmly on the ground
Load Equipment and remember to set the parking brake.
Secure equipment to the rollback with preferred tie-downs
Be sure each piece is tied down at four points to secure properly.
To unload, reverse the process.
For more information, scan the QR code on the rollback’s headache rack or visit ledwell.com.
See index of operational videos - https://bit.ly/2wxwWda
**********
Subscribe and hit the bell to be notified when new videos premiere - https://bit.ly/2POTMDS
**********
CONNECT WITH US
FACEBOOK - https://www.facebook.com/ledwellandson
INSTAGRAM - https://www.instagram.com/ledwellandson/
LINKEDIN - https://www.linkedin.com/company/ledwell-&-son-enterprises-inc./
TWITTER - https://twitter.com/ledwellandson